Digga Mini Trencher - DO NOT LOCK THE AUXILIARY HYDRAULICS OF YOUR MACHINE IN THE “ON” POSITION.; SAFETY FIRST! READ & UNDERSTAND THE SAFETY INSTRUCTIONS BEFORE BEGINNING ANY TRENCHER OPERATING.; FAILURE TO OBEY THE FOLLOWING PROCEDURES COULD RESULT IN DEATH OR SERIOUS INJURY.; Never lift this product:

7
4 insTallaTion anD oPeraTinG insTrucTions
DO NOT LOCK THE AUXILIARY HYDRAULICS OF YOUR MACHINE IN THE “ON” POSITION.
FAILURE TO OBEY THIS WARNING COULD RESULT IN DEATH OR SERIOUS INJURY.
SAFETY FIRST!! READ & UNDERSTAND THE SAFETY INSTRUCTIONS BEFORE BEGINNING
ANY TRENCHER OPERATING.
Never lift this product:
● Above the operator’s eye level OR to a height where visibility is obstructed, which ever is lower.
FAILURE TO OBEY THE FOLLOWING PROCEDURES COULD RESULT IN DEATH OR
SERIOUS INJURY.
8. Make sure the couplers are fully connected and locked.
9. Route the hoses in such a fashion as to avoid pinching or chang.
10. Check the Chain teeth are not worn. Ensure all worn parts are replaced. Worn parts will become ineffective and severely diminish the
overall performance of the Trencher.
11. The machine is now ready for use.
TO CUT A TRENCH
1. Before operating the trencher, ensure the Crumber bar is pinned in the locked back position.
2. Raise the Trencher so the trencher is horizontal to the ground, with the trencher at approx 200mm off the ground start the rotation
of the chain. Ensure the chain is rotating freely before engaging full RPM.
3. Take the machine to full RPM. With the machine at full RPM engage the trencher into the ground.
4. It will take approximately 1m of trenching before you can operate at the desired depth. With the Crumber Bar still pinned in the
locked back position slowly crowd the trencher over to the desired depth whilst reversing the parent machine.
5. Once the desired depth has been reached. Raise the trencher, stop chain rotation. Use the pin to lock the Crumber Bar forward in
the trenching position. Lower the trencher and continue.
The Crumber has springs to give constant down pressure on the bottom of the trench in order to scoop all spoil missed in
the initial cut of the chain, throwing it back onto the chain to be carried back to the surface.
WHILE CHAIN IS MOVING ALL BYSTANDERS MUST BE A MINIMUM OF 6M/20FT AWAY. IT IS THE
RESPONSIBILITY OF THE OPERATOR TO ENSURE ALL SAFETY PROCEDURES ARE FOLLOWED