107
Check for oil/water leakage and cracking and check for any loose nut or bolt.
Refuel and replace hydraulic oil and lubricating oil.
To prevent rusting and freezing, replace the engine coolant with long-life coolant (LLC).
Lubricate the grease fitting by a grease gun.
Fully retract the bucket and bucket arm cylinders and lower the bucket and bulldozing blade onto
the ground.
Apply anti-rusting oil to the hydraulic cylinders.
Disconnect the negative cable of battery and cover the battery to guard against freezing.
Do not operate the machine in an enclosed place with poor ventilation.
To prevent rusting, operate the machine once a month to circulate the oil throughout whole
system.
Check the battery and when necessary, charge the battery. Please ask your sales or service dealer
for charging.
Start of Machine after Parking
Important: If the above-mentioned “Parking procedure” is not followed during the long-time
parking of machine, please consult with your sales or service dealer before restarting the machine.
Wipe away the lubricating oil from the piston rods of the hydraulic cylinders.
When necessary, add lubricating oil or grease.
Fulfill the daily checking.
Pre-lubricate the engine before start.
Crank the engine for 15s and notice to keep the fuel system closed to prevent start of engine.
Stop for 30s.
Repeat this procedure, till the engine is already cranked for 1min in total. This can enable the
sufficient oil circulation throughout the lubrication system of engine.
Prepare the fuel system.
Start the engine. Idle the engine for approximately 15min and then:
Check for normal oil pressure.
Check for leakage of fuel, engine oil, and coolant and check indicator lamps and/or level gauge
for normal functioning.
Avoid operating for a long time at minimum or maximum engine speed or operating the loaded
residue within the first loading hour.
To Next Page
Loading...
Need help?
General