26
Precaution during Transport
Safe loading/unlocking of machine
The machine may roll over or fall off during
loading and unloading. Ensure to take the
following safety measures:
Select a solid and level ground and keep a
sufficient spacing from the road curb.
Fix the ramps of sufficient strength and
dimensions to the cargo body of truck. The inclination of the ramps shall not exceed 15°. If the
ramps deflect downward excessively, please support the ramps by supports or cushion blocks.
Do not load or unload the machine by working device. Otherwise, it may result in rollover or
falloff of machine.
Keep the truck cargo body and the ramps clean without oil, sand, ice/snow, or other impurity, in
order to prevent the sideslip of machine. Clean the tracks.
Block the wheels of transport truck by wedges to prevent movement. While loading or unloading
the machine, drive the machine slowly in 1st gear (low speed) as per the signals of the signaler.
Do not change direction on ramps.
Do not slew/swing on ramps. Otherwise, the machine may roll over.
Slewing (swinging) the machine on the cargo body of truck may result in unstable legs of
machine. Therefore, operate slowly.
If possible, lock the cab doors after loading. Otherwise, the cab doors may open during the
transport.
Plug securely the tracks by wedges and then fix the machine to the truck cargo body securely by
ropes or chains.
Safe Lifting of Machine
Master and utilize the correct lifting gestures. Daily check the lifting device for damaged and
missing parts and when necessary, replace. Please use the ropes of sufficient capacity for the
machine weight during lifting.
Lift the machine as per the procedure described below. Do not operate by any other method,
otherwise it may result in unbalance of machine. Please refer to the section “Lifting of Machine”
to understand more description information.
To Next Page
Loading...
Need help?
General