24
attachment end is heavier than that with standard
bucket. For machine with such heavy end, do not face
the bucket arm (boom) towards downslope direction for
digging or towards lateral direction for operations.
If the bucket is fully loaded with material, avoid slewing
towards the downslope direction. Otherwise, it will
deteriorate the machine stability and probably result in
rollover.
Guard against Overhead Objects
During operations under bridges, in tunnels, near
cables, or indoors, guard the boom and bucket arm
against impact with any overhead object.
Not Designed for Lifting Application
This machine is specially designed for digging
operations. Therefore, it’s not installed with safety
devices for lifting operations. Take special caution while
using this excavator for lifting operations.
Do not overload during lifting. The overload will result in rollover of machine which may cause
serious injuries or deaths.
All rated lifting capacities are based on the condition of using this machine on a firm and level
ground. The user is recommended to reserve an appropriate allowance for specific working
conditions, in order to ensure the safe lifting operations. The soft or uneven ground, non-level
status, lateral load, dynamic or sudden load, dangerous environment, and personnel experience
are included. Before operating the machine, the operation personnel and other personnel must
be familiar with the Operation Manual. The safe operation regulations of the machine must be
strictly followed in all cases.
If the chain or lifting device is incorrectly connected, the bucket connecting rod, or the lifting
device may fail and could cause serious injuries.
While using this machine as a crane, do not attempt to pull out a stump from the ground. For this
application, the load applied onto the machine is completely unknown.
Do not allow any person to stand on or beneath the lifted object or close to the operation zone.
To Next Page
Loading...