28
No Access of Non-Authorized Personnel
During operations, the non-authorized personnel are
prohibited to access the working zone. Take caution during
grinding, welding, and use of hammer. You may be injured
by the flying fragments from the machine.
Preparations of Working Zone
Select a stable and level working zone. Ensure the
appropriate illumination conditions. For indoor operations,
keep well ventilated. Remove obstacles and dangerous
goods. Clear slippery areas.
Always Keeping Clean Machine
Please clean the machine before maintenances. Stop the engine
before cleaning the machine. Cover the electric parts against water
ingress. The water ingress into the electric parts may result in short-
circuit or malfunction. Do not clean the battery, electronic control
units, sensors, connector, or cab by water or steam.
Stop of Engine before Maintenances
While the machine is working, or the machine is not working but the engine is running, avoid
lubricating or further adjusting the machine.
If the maintenance requires the running of engine, assign two operators for team work and keep
contact with each other.
One operator must sit in the driver seat to get ready to stop the engine immediately when
necessary. This operator must pay special attention not to touch any joystick or pedal, unless it’s
absolutely necessary.
The other operator for the maintenance must keep their body and clothing away from motion
parts of machine.
To Next Page
Loading...