71
Fixing of Machine
After loading the machine to designated position, fix as per following requirements.
Lower the bulldozing blade.
Sufficiently extend the bucket cylinder and bucket arm cylinder and then lower the boom.
Lift up the safety lock handle to the locking position.
Stop the engine, withdraw the starter key, and lock all locks.
Place the stop blocks (Wedges) on the front and rear of tracks.
Affix chains or ropes securely to the lower framework of machine, in order to prevent the sideslip
of machine.
Fix the bucket by chains or ropes.
Safety Measures Taken during Transport
During the transport of machine, understand and abide by all applicable safety rules, vehicle
codes, and traffic
regulations.
Take the length, width, height, and weight of the transport truck with loaded machine into
consideration, in order to select the best transport route.
During the transport, do not start up or stop the transport truck suddenly or drive at high speed.
Otherwise, it will result in movement or unbalance of loaded machine.
To Next Page
Loading...
Need help?
General