Digi ConnectPort LTS 16 User Manual

Configure the device using the ConnectPort LTS web interface Configuration through the web interface
Digi ConnectPort LTS User Guide
44
The assumed default base is 2000. For example, the telnet passthrough service is set to network port
2001 for serial port 1, 2002 for serial port 2, and 2003 for serial port 3, and so on.
If you change a network port for a particular service, that is the only network port number that
changes. That change does not carry over to the other network ports. For example, if you change the
network port number for telnet passthrough from 2001 to 3001, that does not mean that the other
network ports changes to 3002, 3003, and so on.
There are two types of network services available:
n Basic services: You can access these services by connecting to a particular well-known
network port.
n Passthrough services: You can set up a specific type of service for a specific serial port. To use
the service, you must use the correct protocol and specify the correct network port. For
example, assuming default service ports and using a Linux host, here is how a user would
access the SSH and telnet passthrough services on port 1:
#> ssh -l fred digi16 -p 2501
#> telnet digi16 2101
The following table shows the network services, services provided, and the default network port
number for each service.
Service Services provided
Default network
port number
Device Discovery, also
known as Advanced Digi
Discovery Protocol (ADDP)
Discovery of Digi devices on a network. Disabling
this service disables use of the Digi Device
Discovery utility to locate the device. You cannot
change the network port number for ADDP from
its default.
2362
Encrypted (Secure) RealPort Secure Ethernet connections between COM or
TTY ports and device servers or terminal servers.
1027
RealPort A virtual connection to serial devices no matter
where they reside on the network.
771
Line Printer Daemon (LPD) Allows network printing over a serial port. 515
Modem Emulation Pool
(pmodem)
Allows the Digi device to emulate a modem.
Modem emulation sends and receives modem
responses to the serial device over the Ethernet
instead of Public Switched Telephone Network
(PSTN). You can enable or disable telnet
processing on the incoming and outgoing
modem-emulation connections. The pmodem
service is for connecting to whatever serial port
will answer.
50000
Modem Emulation
Passthrough
Allows the Digi device to emulate a modem. This
service is for dialing in to a particular serial port
that has been set up for modem emulation.
50001

Digi ConnectPort LTS 16 Specifications

General

Brand	Digi
Model	ConnectPort LTS 16
Category	Server
Language	English