Digi ConnectPort LTS Series User Manual

Configure and manage the device using the ConnectPort LTS command line interface Administration
Digi ConnectPort LTS User Guide
141
Administration
You can issue commands from the command-line interface to administer ConnectPort LTS products.
The following table displays several administration tasks and the commands used to perform them.
See the Digi Connect® Family Command Reference for more complete command descriptions.
Administrative task Command
Backup/restore a configuration from a
TFTP server on the network
backup to=serveripaddress[:filename]
Update firmware boot
To update the firmware:
1. Telnet or ssh to the Digi device command-line
interface using a telnet/ssh application.
2. A login prompt appears. The default user name is
root and the unique default password is printed on
the device label. If the password is not on the device
label, the default password is dbps. If neither of the
defaults work, the password may have been
updated. Contact your system administrator.
3. If you are at the bash shell, type configshell to get
to the config shell.
4. Issue the boot load command:
#> boot load= tftp-server-ip : filename
Replace tftp-server-ip with the IP address of the
TFTP server that contains the firmware, and
replace filename with the name of the file to upload.
Reset configuration to factory defaults revert
or
boot action=factory
Display system information and
statistics
info
Reboot the device boot
Enable/disable network services set service
Configure device server for tracing and
display tracing information
set trace

Digi ConnectPort LTS Series Specifications

General

Brand	Digi
Model	ConnectPort LTS Series
Category	Server
Language	English