Digi ConnectPort LTS Series User Manual

Configure the device using the ConnectPort LTS web interface Peripheral
Digi ConnectPort LTS User Guide
93
o
Establish connection to the following network service:
o
Server (name or IP): Type the IP address or host name of the destination device.
o
Service: Select the service type of the connection. Your options are as follows:
o
Raw TCP—If you are bridging to another Digi device server use Raw TCP.
o
Rlogin
o
Secure Sockets
o
Telnet
o
SSH
o
TCPPort: Type the TCP port number of the destination device. The standard port
numbers are 23 for telnet and 513 for rlogin. If you are bridging to another Digi device
server use the raw TCP port number for its serial port. This is usually 2101 for port 1.
The format for this port number is as follows:
21<serial port number>
Replace <serial port number> with the Digi serial port number. For example, 2101
applies to serial port 1, 2110 applies to serial port 10, and 2116 applies to serial port
16.
See Assign a profile to a serial port for more information about assigning a Serial
Bridge (Serial Tunneling) profile to a serial port.
o
Enable Keep-Alive: When selected, enables the Keep-Alive feature.

Digi ConnectPort LTS Series Specifications

General

Brand	Digi
Model	ConnectPort LTS Series
Category	Server
Language	English