Digi Connect and ConnectPort TS Family web interface Configuration through the web interface
Digi Connect Family and ConnectPort TS Family
93
1. Configure the wireless card to operate in Ad-Hoc mode with the SSID - Connect.
2. Power up the device.
3. Launch the Discovery application on you computer and proceed with the configuration.
Set DIP switches on Digi Connect Wi-SP (or SP)
To set the DIP switches on Digi Connect Wi-SP (or SP):
1. Disconnect the power supply.
Note ALWAYS disconnect the power supply before resetting the DIPswitches.
2. Set the Digi Connect Wi-SP DIP switches in the On or up position. The following image shows
the DIP Switch settings required for command-line access for both the Digi Connect Wi-SP and
the Digi Connect SP.
3. Connect the Digi Connect Wi-SP to a computer with a serial cable.
4. Access a terminal emulation program such as HyperTerm. For example, select Start >
Accessories > Communication > Hyperterm and type a name for the connection.
5. Select COM1 and click OK.
To Next Page
Loading...
Need help?
General