Digi SM-5100 - Page 100

SM – 5100 Operation Manual
100
(Ex.
MSG#1=1:NORMAL,MSG#
2=2:FAST and
MSG#3=0:SLOW)
[PLU]
S14
→
SCROLL
SEQUENC
Store the Scroll message 1
data, back to S mode.
The scrolling pattern is as following.
0: L–SCROLL: Maximum100 characters
1: BLINKING: Maximum 25 characters
2: STATIS: Maximum 25 characters
3: R –SCROLL: Maximum100 characters
4: WIPE IN: Maximum 25 characters
4.22.2 Enable or Disable Scroll Sequence File
This Function is used to enable the programmed Scroll Message data by Scroll Sequence Number
shows on the Display in Registration Mode when scale in idle time. The Scroll Message,
Scrolling Pattern and Speed will follow Scroll Sequence Number setting.
Enable Scroll Sequence File
At Scroll Sequence programming Mode, enter Scroll Sequence Number you want (Ex. 1).
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
S14.0
SC SQ
0
NO SET
Enter Scrolling Sequence
programming mode.
[1]
S14.0
SC SQ
1
NO SET
Enter Scrolling Sequence file
number.(Ex. 1)
[PLU]
S14
→
SCROLL
SEQUENC
Enable Scrolling Sequence
Number 1, back to S mode.
Note1: If you want to change the Scroll Sequence number, enter new sequence number follow by press [PLU]
key.
Disable Scrolling Message
At Scroll Sequence programming Mode, enter Scroll Sequence Number you want (Ex. 0).