Digi SM-5100 - Page 99

SM – 5100 Operation Manual
99
S13.0
SC
MG
0
NO SET
Enter Scrolling Message
programming mode.
[1]
S13.0
SC
MG
1
NO SET
Enter Scrolling Message
number.(Ex. 1)
[－]
S13.0
SC
MG
DEL ?
Y-C N-T
Enter delete mode.
[C] for Yes,[T] for No.
[C]
S13
→
SCROLL
MESSAGE
Delete Scrolling Message File 1,
back to S mode.
Note1: If you want to cancel the deletion, press [T] key to exit.
Note2: Non-existing Scroll Message File can not be deleted.
4.22 Scroll Sequence File
Scroll Sequence # 1 to # 3 is available. Each scroll sequence consists of up to three kinds of
Messages. Scroll Sequence means the scroll display order and display appearance of the
programmed scroll message.
4.22.1 Program Scroll Sequence File
At Programming Mode, select Scrolling Sequence programming mode and then enter new Scroll
Sequence number (Ex. 1) programming mode. *For edit, enter existing Scroll Sequence Number.
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
S1
→
PLU
FILE
Enter S mode.
[1][4][*]
S14.0
SC SQ
0
NO SET
Enter Scrolling Sequence
programming mode.
[1][*]
S14.1
SC SQ
MSG NO
000
Enter Scrolling Sequence file
number.(Ex. 1)
[1][2][3][*]
S14.2
SC SQ
ATTRIB
123 000
Enter existing Scrolling
Message Number.(Ex. 1, 2, 3)
[1][2][3][*]
S14.2
SC SQ
SPEED
123 000
Select Scrolling pattern for
each Scrolling Message.
(Ex. MSG#1=1, MSG#2=2 &
MSG#3=3)
[1][2][0]
S14.2
SC SQ
SPEED
123 120
Select Scrolling Rate.