SM – 5100 Operation Manual
34
Note1: For tax rate programming, refer to 3.20 Tax File in S Mode. if not necessary to link the Tax Number,
press [*] key to enter next selection. This procedure will skip if SPEC 603 is set to "NO TAX".
Note2: Number after "NAME" in Total display shows the position of the cursor.
Note3: The Main Group No.1 to No.997 are available for PLU programming.
(No.997 is default No. for PLU programming, and the PLUs which are not linked to any Main Group
No. are assigned to No.997)
(Non-PLU files (Weighing items) are assigned to Main Group code No.998)
(Non-PLU files (Non-weighing items) are assigned to Main Group code No.999)
Note4: The Main Group names programmed are not printed on the label/receipt but are for reporting.
Note5: Each Main Group No. must be linked to the exiting Dept. No.(Refer to 3.3 Department File).
To Next Page
Loading...
