Digi SM-5100 - Page 56

SM – 5100 Operation Manual
56
[PRESET 1]
S4.0
PS AS
0
NO SET
PLU No.100 had been assigned
to Preset Key 1.
[◇][C]
S4
→
KEY
ASSIGNMENT
Back to S mode.
Note1: Non-existing PLU No. can not be assigned.
Note2: If assigning PLU Number 50 to the Preset key No. 1 has been already programmed, the PLU No. 50
will replace the old data of Preset Key No. 1, but PLU Number cannot replace the preset key are
already assign for Function Key, Vender Key or Preset Tare.
4.8.2 Function Key Assignment
By assigning the following function keys to Preset keys, the functions can be used by touching the
assigned keys
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
[MODE][MODE]
[MODE]
S1
→
PLU
FILE
Enter S mode.
Lamp S turns on.
[4] or [ ︾ ] three
times
S4
→
KEY
ASSIGNMENT
Key Assignment mode is MENU
4 in S mode.
[*]
S4.0
PS AS
0
NO SET
Enter PLU assignment mode.
[*]
S4.1
VR AS
0
NO SET
Enter Vender Key assignment
status.
[*]
S4.2
FN AS
0
CLEAR
Enter Function Key assignment
status.
[X][X]
S4.0
FN AS
2
-PRICE
Select PRICE DISCOUNT
function
[PRESET 25]
S4.2
FN AS
0
CLEAR
PRICE DISCOUNT function had
been assigned to Preset Key
number 25.
[◇][C]
S4
→
KEY
ASSIGNMENT
Back to S mode.
Note1: Non assigned Preset Key can be set as function key.