Digi SM-5100 - Page 74

SM – 5100 Operation Manual
74
4.16.2 Print Area, Print Position and Print Angles
All changeable item data should be programmed 8mm above the bottom of the label. The
bottom 8 mm of the label should be used for invariable data such as shop name, since this area is
printed when issuing the last label. Please do not program any item closer than 1mm to the
edges of the label.
The print position of each item is determined by setting the interval from "0" point (X=0, Y=0)
to the base position of the programmed item. X and Y values need to be entered by "mm".
Print Area
The item data cannot be printed at the bottom 10 mm of labels. Pre-print data such as shop name
or logo data is programmed at the bottom 10mm. Also the item data should not be printed
within 1mm from the left edge or the right edge of the label as the following drawing shows.
Label width
1mm 1mm
Free Format Space
Label length
Pre-print area
(e.g,Shop Name)
10mm
Label gap