Digi SM-5100 - Page 75

SM – 5100 Operation Manual
75
Print area
Area printed by a
print operation
Print Position
The printing position of each item data is decided by setting the distance from 0 point (X=0,
Y=0) to the base position (X value, Y value).
Label width
Area printed by a print operation
Label length
x
Item data
y
x=0
y=0
10mm
Print Angle
Print angle of each Print Item can be selected from 4 different angles, 0 degree, 90 degree, 180
degree, and 270 degree. A whole format base or each Item Data-base may set print angle.
According to the selected print angle, the status of print position differs as the following samples.
x