Digi SM-5100 - Page 83

SM – 5100 Operation Manual
83
Base Type 4
Item data in Data Base 4 is Frame data. The print position of Frame data may be programmed
by setting X value, Y value, X1 value, Y1 value [the opposite point against the point (X,Y) on a
diagonal line], and line weight.
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
Continued from the procedure Basic Setting: (width, height, angle and label type)
S12.5
FRM 1
← 22
F ITEM
Item setting: Frame 1.
[*]
S12.5
FRM 1
0
X MM
Enter X value.(Ex.10mm)
[1][0][*]
S12.5
FRM 1
0
Y MM
Enter Y value.(Ex.1mm)
[1][*]
S12.5
FRM 1
0
X1 MM
Enter X1 value.
The X1 of frame 1 printing area is
20mm.(Ex. 20mm)
[2][0][*]
S12.5
FRM1
0
Y1 MM
Enter Y1 value.
The Y1 of frame 1 printing area is
15mm.(Ex. 15mm)
[1][5][*]
S12.5
FRM 1
0
STATUS
Enter print status.(Ex. All item print)
[7][*]
S12.5
FRM 1
0
T MM
Enter line weight.
The line weight of frame 1 printing area
is 2mm.(Ex. 2mm)
[2][*]
S12.5
FRM 1
← 22
F ITEM
Enter next item setting.