Digi SM-5100 - Page 82

SM – 5100 Operation Manual
82
Base Type 3
Item data in Data Base 3 is Barcode data. The print position of bar-code data can be
programmed by setting X / Y value, width of Barcode from X value, height of Barcode from Y
value and print angle.
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
Continued from the procedure Basic Setting: (width, height, angle and label type)
S12.5
BARC
D
← 12
F ITEM
Item setting: Barcode.
[*]
S12.5
BARC
D
0
X MM
Enter X value.(Ex.5mm)
[5][*]
S12.5
BARC
D
0
Y MM
Enter Y value.(Ex.20mm)
[2][0][*]
S12.5
BARC
D
0
DG ANGLE
Select print angle.(Ex.90 degree)
[>>][*]
S12.5
BARC
D
0
HT MM
Enter height value.
The height of shop name printing area
is 25mm.(Ex. 25mm)
[2][5][*]
S12.5
BARC
D
0
STATUS
Enter print status.(Ex. All item print)
[7]
S12.5
BARC
D
7
STATUS
The status of BARCODE printing area
is all item printing.
[*]
S12.5
BARC
D
← 12
F ITEM
Enter next item setting.