Digi SM-5100 - Page 89

SM – 5100 Operation Manual
89
selection.
[PLU]
S12
→
FREE
FORMAT
Save the Free Format number
8.
4.17 Place File
PLACE file is used for programming a short text describing the place of production. The
number of Characters possible to enter depends on the PLACE print area size and the character
size used. Place will be printed in the free room of Commodity Name print area if selected label
format without Place print area. Maximum 99 places (Place number 1 ~ 99) can be programmed,
each with 1 line.
4.17.1 Program Place File
At Programming Mode, select Place programming mode and then enter new Place number (Ex.
1).
*For edit, enter existing Place number.
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
S1
→
PLU
FILE
Enter S mode.
[1][5][*]
S15.0
PLACE
0
NO SET
Enter Place File programming mode.
[1][*]
S15.1
P01.01
S1 A100
Enter place file No.(Ex. No.1)
[M][A][D][E][SP]……
S15.1
P01.13
DIGI
S1 A 88
Enter the Place File as the same
procedures as Commodity Name
Entry.
(Ex. “MADE IN DIGI”)
[SIZE][SIZE]…
S15.1
P01.13
DIGI
S5 A 48
Change font size to S5.
(S1~S5; M1~M5; L1~L5)
[PLU]
S15
→
PLACE
FILE
Store Place File 1,back to S mode.
4.17.2 Delete Place File
At Place programming mode, enter existing Place Number (Ex. 1) to be deleted.