Digi SM-5100 - Page 88

SM – 5100 Operation Manual
88
[*][*][3][2]
S12.5
COMM
23
Y MM
Enter Y position setting mode
and change it from 23 mm to 32
mm and go to next selection.
[*]
S12.5
COMM
0
DG ANGLE
Change print angle.( Ex. No
change)
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
[*][*][1][5]
S12.5
COMM
15
HT MM
Enter TTL Height setting
mode, change the height from
21 mm to 15 mm and go to
next selection.
[*]
S12.5
COMM
7
STATUS
Enter print status. ( Ex. No
change)
[*]
S12.5
COMM
← 8
F ITEM
Save the Commodity Name
print setting.
[2][0]
S12.5
INGR
← 20
F ITEM
Select Ingredient program
mode.
[*]
S12.5
INGR
0
X MM
Enter Ingredient programmable
mode.
[2][*]
S12.5
INGR
0
Y MM
Enter X Position value (Ex.
2mm) and go to next selection.
[2][3][*]
S12.5
INGR
0
DG ANGLE
Enter Y Position value (Ex.
23mm) and go to next selection.
[*]
S12.5
INGR
0
WT MM
Change print angle (Ex. No
change).
[5][4][*]
S12.5
INGR
0
HT MM
Enter WIDTH value (Ex.
54mm) and go to next selection.
[1][0][*]
S12.5
INGR
0
STATUS
Enter HEIGHT value (Ex.
10mm) and go to next selection.
[7][*]
S12.5
INGR
← 20
F ITEM
Select print status (Ex. 7 = ALL
PRINT) and go to next