How to test a WR11 router step by step.
Page | 20
8 CHECK ETH PORT
Note that it is not necessary to test Eth port 0. This was testing during the flashing process. However if
you observe intermittent issues, it might be necessary to run several tests.
Configure eth port 0 with a valid and free IP address on the same subnet as your test PC, e.g.
eth 0 ipaddr 10.1.208.11
From your PC, first clear the ARP table, from the windows command prompt and issue this command:
arp –d *
Then check that you can ping this IP address. If an intermittent issue is observed, let the ping run for a
longer period (-t option)
If it is not possible to ping this addresses and if you repeat this test on a known good WR11 and it
works fine, please request an RMA with code “ETH 0 test failed”.
To Previous Page
Loading...
