How to test a WR11 router step by step.
Page | 3
1 INTRODUCTION
1.1 Outline
Should it happen that the boot loader becomes corrupted on a WR11 product, it is possible for an end
user to re-load the boot loader by following this guide.
The symptoms of a corrupted boot loader are usually as follows. When applying the power, the only
LED to illuminates is the power LED. It is also possible that other “unusual” LED patterns may occur
depending upon how “damaged” the boot loader is.
1.2 Assumptions
This guide has been written for use by technically competent personnel with a good understanding of
the communications technologies used in the product and of the requirements for their specific
application.
This quick note applies only to:
Model: Digi Transport WR11
1.3 Corrections
Requests for corrections or amendments to this documentation are welcome and should be
addressed to: tech.support@digi.com
Requests for new quick notes can be sent to the same address.
1.4 Version
To Next Page
Loading...
