Digi TransPort WR11 - Page 8

Digi TransPort
®
WR11 Installation Guide
Page 8
Digi TransPort WR11 Provisioning
CDMA provisioning is different from GSM since CDMA (in most cases) does not use a SIM card. The CDMA
module provisioning process creates a CDMA data connection to the mobile carrier network. This authenticates
the modem and retrieves account information which is written to ash memory on the CDMA module itself, not
the Digi’s conguration le. Mobile account information is stored on the CDMA module. Therefore, you cannot
remove provisioning information from the CDMA module by performing a factory reset on the TransPort WR11
device.
If provisioning fails (the device does not obtain a phone number), contact the carrier and verify that the device
has an active account. You will need to provide the MEID of the device which is available under Management
- Network Status > Interfaces > Mobile.
The status of a successfully provisioned CDMA module is shown in the following image. Note that the device
has obtained a phone number.