Digicom 2G GSM Gateway Lift User Manual

ENG3.4
2G GSM Gateway Lift Remote Control via SMS
3.2.4. LOW BATTERY: WARNING MESSAGES
When the above mentioned situations occur, if 2G GSM Gateway Lift is correctly configured, it will send the following messages:
14#*B#DIGICOM#Battery Low (Approximately 90 - 60 minutes* of battery autonomy)
15#*B#DIGICOM#Shutdown in progress (Approximately 30 - 5 minutes* of battery autonomy)
Key of message Battery low: *B
* : The battery life depends on several factors, i.e. the device status (standby mode or talking mode), the operating temperature
of the device, the quality of GSM signal.
3.3. CONFIGURATION RESET
To recover the factory default configuration of *1 and *2 messages, it will be necessary to send the following SMS:
*9 # ID
ITEM DESCRIPTION
*9 Message ket to recover the factory default configuration
# Separation symbol
ID Device ID
This command will restore all the default values of the SMS configuration.
Example:
*9#DIGICOM
3.4. DEVICE REBOOT
Authorized users can remote reboot the device with the following message:
RESET
After the reception of the message, the device answers with an ACK message then it re-boot the device for a new GSM network
searching.
Example:
18#RESET#DIGICOM#ACK

Digicom 2G GSM Gateway Lift Specifications

General

Brand	Digicom
Model	2G GSM Gateway Lift
Category	Gateway
Language	English