DigiDesign Digi 002 & Digi 002 Rack User Manual

Digi 002 and Digi 002 Rack Basics Guide
18
Controlling Delay (Latency) During Monitoring
Pro Tools LE with Digi 002 or Digi 002 Rack uses
your computer for all audio processing, play-
back, and recording. This causes a small amount
of audio delay, or latency.
Latency is most obvious when monitoring dur-
ing recording. You may hear this as a slight de-
lay between when you produce the sound and
when you hear the sound through the speakers
or headphones.
Pro Tools LE for Digi 002 and Digi 002 Rack sys-
tems includes Low Latency Monitoring. This
feature allows you to use a built-in mixer in the
Digi 002 unit or Digi 002 Rack unit when re-
cording or monitoring to lessen the effect of la-
tency.
To use Low Latency Monitoring, tracks must be
record-enabled, assigned to an actual audio in-
put (not a bus), and assigned to outputs 1 or 2.
To use Low Latency Monitoring while recording:
1 Launch Pro Tools and set up a session. See
“Recording a Pro Tools Session” on page 8.
2 Select Options > Low Latency Monitoring.
When Low Latency Monitoring is enabled, any
plug-ins and sends assigned to record-enabled
tracks (routed to Outputs 1–2) are automatically
bypassed, and must remain bypassed. Also,
these tracks will not register on meters for Mas-
ter Faders.

DigiDesign Digi 002 & Digi 002 Rack Specifications

General

Brand	DigiDesign
Model	Digi 002 & Digi 002 Rack
Category	Recording Equipment
Language	English