Digikeijs DR4024 User Manual

DR4024 Servodecoder
A

 !"#$%&
$'()(''
(
 $01,""0
 60,11(7-L&
 /,,0",0
 /,0"0P?/@
/""",2""MM/+
 #00,950
 900,"10;0"7'
 /,0P010
 60000
 610"11"0P00

Digikeijs DR4024 Specifications

General

Category	Media Converter
Manufacturer	Digikeijs
Model	DR4024
DCC Protocol	Yes
Outputs	4
Configuration	Using DCC commands
Operating Temperature	-20 to +70 °C

Summary

Programming

Programming the Turnout Address

Step-by-step guide to assigning a magnetic article address to the DR4024.

Programming Servo Positions A-D

Instructions for setting four distinct servo positions (A, B, C, D) for each servo.

Programming CVs via POM (Main Track)

Method for programming Configuration Variables (CVs) using Programming on Main (POM).

Programming CVs via Programming Track

Procedure for programming CVs using the dedicated programming track.

Reset DR4024 to Factory Settings (Main Track POM)

Resets the decoder to default settings using the Main Track POM method.

Reset DR4024 to Factory Settings (Programming Track)

Resets the decoder to default settings using the programming track method.

Special Feature: Programming Switches Off Programming Track

Reset for Control Units Switching Off Programming Track

Troubleshooting and Others

Red LED Goes Out During Programming

Servo Installation and Connection

CV Table

Function Mapping