To Next PageTo Next Page
Need help?Do you have a question about the Digikeijs DK50018 and is the answer not in the manual?
General| Manufacturer | Digikeijs |
|---|---|
| Model | DK50018 |
| Category | Media Converter |
| Protocol | DCC |
| DCC Input | Yes |
| Connector Type | RJ45 |
| Data Rate | 100Mbps |
| Input Ports | 1 |
| Output Ports | 1 |
| Supported Media Types | Ethernet |
| Power Supply | External |
Details the 24-month manufacturer's warranty and conditions for its validity.
Covers rights, modifications, printing errors, and reservation of changes.
Provides a general introduction to the DK50018 decoder and its features.
Lists the technical details, dimensions, power, and connectivity of the DK50018.
Explains the terminal designations for outputs, common poles, and signal connections.
Illustrates different methods for connecting power and signal to the device.
Guides users on downloading and using the Digikeijs app for Bluetooth configuration.
Explains the initial app setup options: use without account or create an account.
Step-by-step guide on pairing the DK50018 with the Digikeijs mobile application.
Describes the device management screen in the app, including device status icons.
Details the core functions available in the app: update firmware, start config, switchboard, reset, lock.
Covers loading presets on all outputs, per output, and custom configurations.
Lists available presets and the addresses they occupy.
Explains how to apply a chosen preset to all device outputs simultaneously.
Details the process of assigning specific presets to individual outputs.
Step-by-step guide for setting the device's start address using DCC commands.
Explains how to program the device using Program On Main (POM) with a DR5000.
Instructions for setting the device address using the Z21 App.
Details POM programming procedures using the Z21 App.
How to set the device start address using the Multimaus controller.
Step-by-step guide for POM programming with the Multimaus.
Demonstrates setting the base address using the Uhlenbrock Intellibox.
Explains POM programming procedures with the Uhlenbrock Intellibox.
Instructions for setting the start address using a Lenz control unit.
Details POM programming steps using a Lenz control unit.
Explains how to perform a factory reset on the device via POM.
Addresses the issue of the programming mode deactivating unexpectedly.
Explains that a red LED indicates a short circuit and how to resolve it.
Provides troubleshooting steps for Bluetooth detection issues.
Instructions on unlocking the device and re-enabling Bluetooth.
Discusses known compatibility issues with Z21 stations and recommended settings.
