DK50018 - Bluetooth accessory and switching decoder Bluetooth connecon
DK50018 - Bluetooth accessory and switching decoder
www.digikeijs.com
*R-Bus, B-Bus are registered trademarks of Modelleisenbhan GmbH. XpressNet and RS-Bus are registered trademarks of Lenz 30www.digikeijs.com
*:POM stands for Program On the Main and corresponds to the direct programming on the track or "track output" of the control unit.
4.1.9 Programming with a Lenz control unit in
POM* mode
In the following example we will program the DK50018 to use preset 2 using
CV47— Value 2
1. Connect the DK50018 to the main channel output of your LZV100 or higher.
2. Press the [CI] buon and enter the locomove address 9999.
3. Press the [F] buon unl [*Pom*] appears on the LH100 display, then press [Enter]
unl [*CV*] appears and press [Enter] again.
4. Enter the CV you want to change, in this case cv 47 and value 2 and press [ENTER]
again.
5. Press the DK50018 buon and the yellow LED should light up.
6. Press [ENTER] to send the modied CV value.
7. To exit the DK50018 programming mode, press the module buon again and the yel
low LED on the decoder should go o, indicang that the change has been stored.
To Next Page
Loading...
Need help?
General
