The supplied remote control can be programmed
to also manage some functions of the TV remote
control (e.g. volume management, switch-off,
channel change). To assign TV functions to the
receiver remote control, it is necessary to use the
TV CONTROL section at the top of the remote
control, follow the procedure below:
TV CONTROL
TV remote control
setting.
In the TV
CONTROL section
press the SET
button for 3 seconds, the red LED will increase in
intensity. In the same section press the key to set
(e.g. V+), the red LED will flash.
Place the TV remote control in front of the decoder
remote control (so that the two sensors face each
other) at a distance of about 3 cm.
On the TV remote control, press and hold the
button to be set (e.g. VOL+) until the red led
remains steady. Press the SET button to save.
Set one button at a time.
NOTE: the screen printing on the 3 programmable
keys is indicative because you can assign them
the function you want.
To Next Page
Loading...
