on the right. Use the button to enter the column
on the right and the / buttons to select the
desired event. Press the INFO button to open the
program description. Use the YELLOW button to
switch between the columns. Press the OK key
(timer) to book the display of the selected event.
Press the BLUE (Set timer) button to view the
various schedules saved in the timer. Press EXIT
to leave the EPG.
GETTING STARTED
The first time you turn on the decoder (or when
you reset it) you need to tune the channels.
CAUTION: if no picture appears, you may need to
select the source for the input used (e.g. HDMI 1
or 2 etc.), by pressing the SOURCE button on the
TV remote control (depending on the brand it may
also be identified with INPUT, AV, AUX, ZERO,
etc.).
In the “Installation Guide” screen, scroll through
the items using the button: select language and
country using the buttons .
In order to use several functions supported by the
decoder, you need to enter the access PIN. Use
the ▼ button to scroll down do New Password and
enter the desired PIN, consisting of 4 digits (e.g.
0000 or 1234 etc.), using the numeric keys of the
remote control: make sure to write it down in the
following spaces, if you lose your PIN contact the
service department.
□□□□
Enter your PIN again in Confirm Password. Go to
Next and press OK button to go to the next screen.
NOTE: we recommend you to do not make any
changes on the following screens of the
To Next Page
Loading...