Op2 Name
Name: Low
Op4 High source
source: sum A+B
Copy Output Data
[ENTER] to Copy
Source Output: [1]
Source Output: [1]
Target Output: [2]
Source: 1 Target: 2
[ENTER] to Confirm
Each channel include a separate Limiter, it includes: threshold LEVEL (-20dB~+15dB),
attack time (1~100ms), Hold time (0~100ms), Decay time (10~1000ms).
H. Name of channel: Rotate Param to change the channel name.
I. Input signal (Signal source selecting )
In this menu, rotate
In this menu,
"Param" to change current channel.
Note: In output menu ( OpXX ), push "Gain" again to change output channel
( Op1... Op6, Op1.....Op6 )
J. Copy function in channels
Press "enter" to enter source output selecting:
I n this menu, rotate Param or press PREV, NEXT to change source output.
Press ENTER to enter target output.
rotate "Param" or press PREV, NEXT to change target output.
Press "ENTER" to confirm channel copy.
88
Operation Instruction
The prameters that can be copied in channels include all above parameters from
A-H points, no copy for channel sources.
To Next Page
