5
B . Basic Picture Taking Operation
NOTE: The camera is designed without a power switch. It uses energy-saving or
“Sleep” mode to control its power. If the camera is off, press the Function Mode button to
turn the camera back on.
1 Pop up the Viewfinder and hold the
camera steady. Look through the
viewfinder and set up your picture.
Adjust size of your composition by
increasing or decreasing distance
between camera and subject but not
nearer than one meter.
2 Press the Shutter button to take a
picture of your subject. A short beep
sound emits at each click of the shutter
to confirm that a shot has been taken
and the camera is ready to take the
next picture.
NOTES: 20 or 80 shots mode is available with erase capability (see next page for
details). After each shot, the LCD Panel will show the number of remaining shots
available.
WARNING: A warning beep (longer and lower tone compared to normal beep) will
emit if exposure is too dark for a normal picture taking. No image is taken when this
condition occurs.
2
1
To Next Page
Loading...
Need help?
General
