Digital Projection E-Vision Laser 7500 Series Important Information

Digital Projection E-Vision Laser 7500 & 8500 Series
Rev D January 2017
Page 19
Important Information
1
POWER
Switches the projector on and off (STANDBY).
2
INPUT
Switches to the next input source.
3
AUTO SYNC
Re-synchronises with the current input signal.
4
ASPECT
Changes the aspect ratio.
5
CENTER LENS
Centers the lens.
6
PIC MUTE
Switches the laser off/on.
7
MENU
Displays and exits the OSD.
8
Arrow buttons & ENTER
Navigation buttons used to highlight menu entries in the OSD.
Press ENTER to open or execute the highlighted menu entry.
9
EXIT
Exits the current OSD page and enters the level above.
10
LENS SHIFT arrow buttons
Each of these buttons moves the lens in the specied direction.
11
FOCUS plus and minus buttons
Used to move the focus in and out.
12
ZOOM plus and minus buttons
Used to zoom in and out.
Projector indicators
TEMP. Off = no problem
Flashing red = temperature error
LIGHT Off = light is switched off
Flashing green = light is preparign to switch on
Flashing red (cycles of six ashes) = light module failure
On, red = light module has reached end of life
On, green = light is switched on
STATUS Off = no problem
Flashing red (continuously) = cover error
Flashing red (cycles of four ashes) = fan error
On, red = system error
POWER Off = the projector is switched off
Flashing green = the projector is warming up
Flashing amber = the projector is cooling down
On, red = STANDBY mode
On, green = the projector is switched on
POWERSTAT U SLIGHTTEMP.

Digital Projection E-Vision Laser 7500 Series Specifications

General

Brand	Digital Projection
Model	E-Vision Laser 7500 Series
Category	Projector
Language	English