AMBE-2000™ Vocoder Chip Users Manual
Version 4.92, June, 08
DVSI Confidential Proprietary, Subject to Change Page 41
Visit us at www.dvsinc.com
Table 6-E Switching Characteristics Over Recommended Operating Conditions for Serial Port
Receive
3.3 Volts
Reference Parameter
Min Max
Units
t
d(SCK)
Delay time, DX valid after CLKX rising
25 ns
t
c(SCK)
Cycle time, serial port clock 6H
ns
t
f(SCK)
Fall time, serial port clock
6 ns
t
r(SCK)
Rise time, serial port clock
6 ns
t
w(SCK)
Pulse duration, serial port clock low/ high 3H
ns
t
su(FSR)
Setup time, FSR before CLKR falling edge 6
ns
t
su(DR)
Setup time, DR before CLKR falling edge 6
ns
t
d(FSX)
Delay time, CLKX rising to FSX
15 ns
t
h(FSX)
Hold time, FSX after CLKX falling edge 6
ns
t
h(FSX)H
Hold time, FSX after CLKX rising edge
2H-5 ns
t
dis(DX)
Disable time, CLKX rising to DX
20 ns
t
h(DX)
Hold time, DX valid after CLKX rising edge -5
ns
• Note: H = 7.629 ns; however, do not operate serial clocks any faster than 2.048 MHz. Thus t
c(SCK)
should be a
minimum of 488.3 nsec.
To Next Page
Loading...
