Digitax F2 - Time and Date Setting; How To Set Time and Date

The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confidential. Any disclosure, copying, distribution to third
party is strictly prohibited.
10
Time and Date Setting
Only for the F2 RTC version
How To Set The Taximeter’s Time And Date
Select For Hire position.
Press K1 and K3 at the same time. The left display will show
“Time” for a few seconds.
Now the signs “FOR HIRE” and “STOPPED” starts blinking.
The big display shows in the left digits the day number and in
right digits the month in ddmm format.
To set the Day number press K1 button.
To set the Month number press K2 button.
To set the Hour press K3 button.
To set the Minutes press K4 button.
Press OP button to enter in the Year programming.
To decrease the Year number press K1 button.
To increase the Year number press K2 button.
Press K3 button to set the taximeter manufacturing year.
Press OP button to end the programmin procedure and go
back to For Hire position