The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confidential. Any disclosure, copying, distribution to third
party is strictly prohibited.
How to program the F2
The F2 can be programmed only through a specific PC software.
In the F2 Pc program it is possible to set all the parameters and save the F2 setup under the proper
town name.
There are two ways to download the programmed data
in the F2 taximeter:
€ by the Red Key
€ by the PC@F2 cable
Programming with the Red Key
When the setup is ready it is possible to transfer from
the F2 PC program to the red programming Key and
from the Red programming key to the F2.
Once the black connector is plugged in the Pc parallel
port, insert the Red Key in the connector top opening to
download the data into the key.
Plug the loaded Red Key in the F2 key connector to download the
data in the F2 memory.
Programming with the PC@F2 programming cable
It is possible to program the F2 direct from the Pc through the specific PC@F2 programming cable.
To Next Page
Loading...
Need help?
General
