EasyManua.ls Logo

DigiTech Artist GSP-2101 - The GSP-2101 and MIDI

DigiTech Artist GSP-2101
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAIN MIDI RECEIVE CHANNEL
The GSP-2101 Artist MIDI Channel Parameter allows you to select the MIDI channel on
which the GSP-2101 Artist will receive MIDI data. This can be set to channels 1 - 16, ALL, or
NONE. If this Parameter is set to ALL, MIDI data received on any MIDI channel will be recog-
nized. If it is set to NONE, the GSP-2101 Artist will not recognize incoming MIDI data.
To set the GSP-2101 Artist’s MIDI channel, do the following:
• Enter the MIDI setup menu by pressing the [MIDI] button once. The display reads:
• Press Function key [1] once. A cursor appears under the number next to MIDI
CHANNEL.
• Use the Data wheel to change the MIDI channel designation. When you’re finished,
press the [MIDI] button to Exit MIDI mode.
NOTE: In order for the GSP-2101 Artist to respond to incoming CCs, the MIDI
CHANNEL setting must match the channel designation of the incoming mes-
sages.
PROGRAM MAPPING
The RECEIVE MIDI PRG (#) AS GSP PRG (#) function allows you to map incoming Program
Changes that are within MIDI range to any Program out of MIDI Program Change number
range on the GSP-2101 Artist. For example, suppose you want to access Program #146 using a
MIDI Program Change. Since MIDI only supports Program Change numbers 1 - 128, Program
Change number 146 would normally be impossible for the GSP-2101 Artist to recognize (or the
sending device to send). With the GSP-2101 Artist's flexible MIDI input mapping, however,
you can assign a Program Change number that MIDI will recognize to be received as Program
#146 on the GSP-2101 Artist.
To illustrate, let's assign MIDI Program Change number 26 to change the GSP-2101 Artist to
Program #131.
• After entering the main MIDI setup menu, press Function key [2] (RECEIVE MIDI
PRG) once. The display reads:
A cursor appears under RECEIVE MIDI PRG. At this moment, MIDI Program
Change number 1 is currently set to activate Program number 1 on the GSP-2101
Artist.
• Using the Data wheel, set the RECEIVE MIDI PRG number to 26. Note as this num-
ber changes, the AS GSP PRG number changes with it.
¡MIDI Channel 1
™Receive MIDI Prg 1
£ as GSP Prg 1
¡MIDI Channel 1
™Receive MIDI Prg 1
£ as GSP Prg 1
63
Section 5 - The GSP-2101 and MIDI
GSP-2101 Artist Owner’s Manual
2101 & MIDI

Table of Contents

Related product manuals