B-COCKPiT BC351 使用说明书
Shenzhen Digitech Co., Ltd. www.riding-evolved.com
Installation
Install the BC351 Unit
1. Use 2pcs M3 Hex Socket Screws 1-1 and 1-2 to secure the mounting bracket to the handle bar.
Tightening torque: 0.2N.m. Do Not Overtighten or it may cause damage to the HMI
2. After adjusting the display to a proper angle, use two M3*6 Hex Socket Screws 2-1 and 2-2 to
tighten it.
3. If you want to install it on a 22.2mm or 25.4mm handlebar, please use the attached adapter
ring.
To Next Page
Loading...
