DigiTech CAT6 - Transmitter Panel Description; Receiver Panel Description

3
PANEL DESCRIPTIONS (TRANSMITTING UNIT):
PANEL DESCRIPTIONS (RECEIVER UNIT):
IR OUT DC 12V
HDMI OUTEDID
HDMI IN
CAT
1. HDMI IN: HDMI signal input port. Connect to HDMI source device such as
DVD or Set-top box.
2. EDID DIP SWITCH: The switch is used for selecting EDID: Switch to the right
position, the extender will copy HDMI loop out display EDID information
to signal source; Switch to the left position, the extender will copy Receiver
display EDID to signal source.
3. HDMI OUT: HDMI signal loop out port. Connect to HDMI display device such
as HDTV.
4. IR OUT: Connect to IR blaster cable, the IR signal is from the IR IN port of
the receiver.
5. POWER LED: When the transmitter is powered on, the LED will be on.
6. CAT: CAT output port. Connect to the CAT input port of the receiver with
CAT6 cable (not included).
7. DIGITAL SIGNAL INDICATOR LIGHT:
Light on: HDMI signal with HDCP.
Light flashing: HDMI signal without HDCP.
Light off: No HDMI signal.
8. DC 12V: DC 12V power supply port.
IR IN CAT
HDMI OUT