5
OPERATION:
TRANSMITTER:
1. Connect the DC plug of the mains power adaptor to the power socket of the
transmitter. Plug-in the mains power adaptor to a 240VAC wall socket.
2. Connect a HDMI cable (not included) from your source device such as PayTV,
DVD player or media player to the HDMI input of the transmitter.
3. Connect a HDMI cable (not included) from the HDMI output of the transmitter
to your TV or monitor’s HDMI input. This will allow you to view your TV or
monitor while extending the signal.
4. Connect a CAT6 ethernet network cable (not included) to the ethernet output
of the transmitter.
5. Connect the infrared (IR) emitter cable to the IR output socket located on the
transmitter.
6. Peel of the 3M sticker located on the back of the infrared (IR) emitter and stick
the emitter in front of the infrared port of your device such as PayTV, DVD
player or media player. The remote control of your device will still work even
with the emitter placed over the top of the infrared port.
Please refer to your device’s user manual if you are unsure of where the infrared
port is located.
RECEIVER:
1. Connect opposite end of the CAT6 ethernet network cable (not included) to the
ethernet input of the receiver.
2. Connect a HDMI cable (not included) from the HDMI output of the receiver to
your TV or monitor;s HDMI input.
3. Connect the infrared (IR) receiver cable to the IR input socket located on the
receiver.
4. Place infrared receiver end in front of your TV or monitor so the infrared can be
controlled.
To Next Page
Loading...