CS-2490
Pole Mounting :This series also include a pole mount option. The
pole mount socket located on the bottom of the speaker may be
used to secure the speaker to a speaker tripod. Always be sure to
fellow the guidelines listed be blow when pole mounting your speaker.
1. Always be sure the stand is designed to support the weight of the
speaker
2.In outdoor situations that are prone to windy conditions and strong
wind gust , be sure to use sandbags as additional tripod support ,
this will greatly reduce the risk of tipping
3.Do not stack speakers on top of each other when mounting on a
tripod. Only one speaker should be mounted to a tripod at one time
4.Always position the tripod legs away from foot traffic
5.Extend the tripod legs to their fully extended position to avoid
accidental tipping
6.Observe and follow all safety guidelines and regulations specified
by the tripod manufacturer
7.Be sure the tripod is situated on a flat ,level , and stable surface
8.Always tighten all tripod locks
OWNER`S MANUAL
Distributed by:
TechBrands by Electus Distribution Pty.Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int`1: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com
To Next Page
Need help?
General