DigiTech DEATHMETAL User Manual

Connections
The Death Metal has a single input (INPUT) and a pair of outputs (AMP
and MIXER). The two outputs give you the following options: running
into a guitar amplifier, running directly to a mixing console or recording
device, or both. The MIXER output uses DigiTech’s speaker cabinet
emulation for an authentic guitar amplifier sound without using an amp.
Follow these setup directions before use:
1.Turn the volume down on the amplifier/mixer you are connecting to.
2. Connect the pedal output to the amplifier/mixer input.
3. Connect the guitar to the pedal input.
4. Connect the power supply to the pedal (optional).
5.Turn the level control on the pedal to the minimum position.
6.Turn up your amplifier/mixer level to the desired listening level.
7.Turn on the pedal by pressing the pedal switch and gradually turn up
the level to the desired listening level.

DigiTech DEATHMETAL Specifications

Power

power supply	9V Alkaline Dry Battery
current draw	21mA (at 9VDC)
power consumption	4.8 Watts (w/optional PS200R power supply)
battery life	approximately 18 hours

Electrical Specifications

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply PS200R - 100	100V ~ 50/60Hz
optional power supply PS200R - 120	120V ~ 60Hz
optional power supply PS200R - 230	230V ~ 50Hz
optional power supply PS200R - 240	240V ~ 50Hz

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs