DigiTech DIGIVERB User Manual

To Enable CIT™ Cabinet Modeling:
Press the pedal down and apply power by connecting a guitar cable to
the DigiVerb input or connecting the PS200R power supply to the AC
adapter jack. CIT™ cabinet modeling has to be enabled each time you
apply power to the DigiVerb.
Battery Replacement
1. Using the tip of a 1/4” guitar cable, push one of the release pins in on
either side of the pedal, and remove the pedal from the pedal chassis.
2. Remove the battery from the battery compartment and disconnect
the battery cable.
3. Connect a new battery to the battery cable and put it back in the
battery compartment. Make sure the battery cable does not interfere
with the spring or pedal switch arm.
4. Place one hole of the pedal over its corresponding pin.
5. Push the opposite pin in and lower the other side of the pedal into
place over the depressed pin. Release the pin. When the pedal is
properly fastened, both release pins are flush with the outer side of
the pedal.

DigiTech DIGIVERB Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
optional power supply	PS200R - 100 (100V ~ 50/60Hz), PS200R - 120 (120V ~ 60Hz), PS200R - 230 (230V ~ 50Hz), PS200R - 240 (240V ~ 50Hz)

Battery

battery life	Approximately 4 hours
power supply	9V Alkaline Dry Battery
optional power supply	PS200R - 100 (100V ~ 50/60Hz), PS200R - 120 (120V ~ 60Hz), PS200R - 230 (230V ~ 50Hz), PS200R - 240 (240V ~ 50Hz)

Ports & interfaces

jacks	Input, Out 1 (Mono), Out 2
input impedance	1 MOhms
output impedance	100 Ohms

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs