Connections
The DigiVerb has a single input and a pair of outputs. Out 1 is used if
the DigiVerb is being connected to only one amplifier. Out 2 is used for
stereo operation. Connect Out 1 to amplifier 1 or the input of a mixer
channel and Out 2 to amplifier 2 or the input of another mixer channel.
The Digiverb can also be connected to the effects send/return of a
mixer. Connect the mixer’s effect send to the In (6) of the DigiVerb.
Connect Out 1 (9) and Out 2 (11) of the DigiVerb to the return(s) of
the mixer. Since the DigiVerb is an effect pedal, a line level signal from a
mixer can distort its input. Adjust the mixer’s effect send control to
reduce any distortion.
CIT™ Cabinet Modeling
The DigiVerb also has built-in CIT™ cabinet modeling. This is a useful
tool when running a distortion pedal into the DigiVerb and then running
direct into a mixer or recorder. CIT cabinet modeling creates a guitar-
through-an-amplifier sound without having to use a guitar amp.
To Next Page
Loading...
