DigiTech RP50 User Manual

Tuner
The Tuner in the RP50 lets you quickly tune or check the tuning of your guitar. Enter the
Tuner by pressing and holding both Footswitches simultaneously. The tu briefly displays
indicating that you are in Tuner mode. To begin tuning, play a note on your guitar (the neck
pickup usually works best). The display shows the note being played. The Effect LEDs
indicate whether the note is sharp or flat. The right 6 red LEDs indicate the note is sharp
and should be tuned down. The left 6 red LEDs indicate the note is flat and should be
tuned up. The center Green LED indicates the note is in tune. The output is muted in
Tuner mode.
When the Tuner is enabled, you can change your tuning reference.The default factory
setting is A=440 Hz. (displayed as 40). Press the Value Buttons to select alternate dropped
tunings. Alternate tunings are A = Ab (displayed as Ab),A = G (displayed as G), and A = Gb
a
The display shows the note played.
LEDs to the left
of the EQ LED
indicate the note is flat.
LEDs to the right
of the EQ LED
indicate the note is sharp.
When the EQ LED is lit,
the note is in tune.
9

DigiTech RP50 Specifications

General

Brand	DigiTech
Model	RP50
Category	Music Pedal
Language	English