4
OPERATION
Bluetooth® Pairing:
1. Connect the plug of the mains power adaptor to the rear power socket of the
sound bar. Connect the opposite side of the mains power adaptor to a standard
240VAC wall socket
2. Press and hold the power button for up to 2 seconds to turn the unit on. The
sound bar will automatically enter Bluetooth® mode and the LED will begin to
flash.
3. Open the settings of your TV, smart phone or tablet and ensure Bluetooth® is
turned on.
4. Once your Bluetooth® is enabled; scan for devices and the Bluetooth® name
XC-5233 should appear. If the name doesn’t appear then please ensure the
speaker is correctly powered on and the correct mode is selected.
Bluetooth® Name: XC-5233
5. Select the XC-5233 on the Bluetooth® device list and your TV, smartphone or
tablet should show that it is now connected.
6. You can now start playing audio from your TV, smartphone or tablet. The
volume can be adjusted from both the speaker and your device. The LED will
stay blue once connected.
TOSLINK Optical Input:
1. Insert a TOSLINK optical cable (not included) to the TOSLINK optical audio
input socket located at the rear of the speaker.
2. Insert the opposite end of the TOSLINK optical cable to an audio device such as
your TV or monitor.
3. The TOSLINK optical mode will automatically start playing once the device has
been inserted.
4. Depending on your brand of TV or monitor being used; you may need to adjust
the audio settings of your TV for the device to be picked up.
5. Make sure that your output sound settings are set on TOSLINK/Optical so that
it’s playing correctly.
6. Open the advanced settings and find the digital audio output format and
change to PCM which should start playing straight away. The settings will dier
depending on the brand of TV.
NOTE: If the speaker can’t be connected; then please restart the speaker or
the device and try again. Press and hold the mode button to disconnect the
current device connected.
To Next Page
Loading...