Receiver
Speaker and Audible Tones
The receiver has a speaker below the trigger area of the handle. The speaker emits warning tones if the
transmitter’s temperature is increasing to indicate that appropriate and immediate attention is required.
Adjusting Screen Contrast
There are two techniques for adjusting the display screen contrast to gradually lighten or darken it. The
receiver must be in locate mode for either technique.
¾ Hold in the trigger while pushing the toggle several times to the right (to lighten) or to the left (to
darken) the display’s contrast.
¾ Push and hold the toggle to the right (to lighten) or to the left (to darken) while clicking the trigger
for the desired contrast.
NOTE: The remote display screen is adjusted in the same way as the receiver except the execute
button serves as the trigger and the toggle arrows work in the same manner as the toggle
switch (see Remote Display section in this manual).
Main Menu
The main system display for the Eclipse software shows the current date/time, the CPU version, and the
DSP version when the unit is first turned on (an example is shown in the figure below). It also shows the
main menu options—Locate, Power Off, Set US, Configure, and Low Fre/High Fre (this option can be
viewed by toggling right past Configure). When an item is selected with the toggle, it is indicated by
arrows on the right and left, as shown in the figure below where the Locate menu is selected.
CPU Version: r1.1.33.1 Oct 30 2006
Tele Ver: 2.12EDRp DSP Ver: 0-4-4
®
Configure
Power Off
Set US
Locate
Receiver Main Menu Display
12 DigiTrak
®
Eclipse
®
Operator’s Manual
To Next Page
Loading...