Target Steering
4. When you have entered the correct target depth number, click the trigger. When the target depth is
programmed and you are in locate mode, you will see a “T” (for target) next to the channel setting in
the lower left corner.
SH
7.5
%
CH:
B1T
75
°
F
411
“T” Indicates
Target Depth Is
Programmed
Receiver Screen with Target Depth Programmed
NOTE: If you are not using the target depth mode, you should set the target depth to 0.00.
Positioning Receiver as Target
The Target Steering procedure requires correct placement of the receiver. The receiver must be placed
out in front of the transmitter with its back end (where the battery pack is inserted) facing the drill. The
maximum horizontal distance from the transmitter that the receiver should be placed is approximately
35 ft (10.7 m).
NOTE: It is very important that the horizontal placement of the receiver as well as the value input
for the target depth number are within the allowable bend radius of the drill string or the
product being installed.
DigiTrak
®
Eclipse
®
Operator’s Manual 55
To Next Page
Loading...