What to do if DigiTrak Test Equipment depth is greater than expected?
If the depth reading on your DigiTrak Test Equipment is greater than expected, the receiver might be set to the wrong frequency. Exit to the main menu, change the frequency setting, and then return to the locate screen to take another depth reading.
Why DigiTrak Remote Display update indicator stops rotating?
The receiver is not in locate mode and, therefore, is not sending data to the remote display. The receiver must be in locate mode to send signals to the remote display. Also, the remote may not be receiving information from the receiver, so try repositioning the receiver and/or the remote to reduce interference.
What to do if DigiTrak Remote Display loses data?
Verify that the receiver and remote display are set to the same channel and that the Tele Option or TLT settings are correct. From the receiver, exit locate mode and then go back into locate mode.
What to do if DigiTrak Test Equipment shows “Recal Tilt” message?
If your DigiTrak Test Equipment displays a “Recal Tilt” message dialog box, the receiver battery may be low. Select “N” for No in the dialog box and replace the battery. If you selected “Y” for Yes, call DCI Customer Service.
Why DigiTrak Test Equipment transmitter battery status icon does not display battery status?
Turn the DigiTrak Test Equipment receiver off and then back on. Go back into locate mode and hold the trigger to view the transmitter battery icon with status bars inside. You can also try changing the transmitter’s battery.
Why DigiTrak Test Equipment pitch, roll, or depth information is different than on remote display?
The receiver and remote display may be set to different channels or using different measurement settings. Verify that both units are set to the same channel, grade mode, and depth measurement mode. If the problem persists with the same settings, try using a different channel.
How to align DigiTrak Test Equipment LL with horizontal cross hairs?
Try lifting the DigiTrak Test Equipment receiver as high as possible. If holding the receiver higher doesn’t help, try taking a step either forward or backward. Then align the LL to the top or bottom of the Eclipse icon rather than the cross hair through the center of the icon.
How to fix DigiTrak Test Equipment LL display?
Position the DigiTrak Test Equipment receiver over one of the two locate points and hold in the trigger for at least one second, then release the trigger. The reference “R” should display at the top of the locate screen and the LL should come up.
What to do if DigiTrak Test Equipment pitch, roll, temperature, and/or transmitter battery status blinks?
If the pitch, roll, temperature, and/or transmitter battery status is blinking on your DigiTrak Test Equipment, move the receiver closer to the transmitter and away from potential interference sources.
Why does DigiTrak Test Equipment display lock up?
If your DigiTrak Test Equipment display locks up or becomes erratic, the battery is likely dead. Replace it with a fully charged battery and click the trigger to power up the unit.
Detailed steps for 1-point and 2-point calibration of the receiver.
How to adjust key settings like frequency, grade, depth units, and telemetry.
Step-by-step guide for locating the transmitter using the Eclipse system.
How to determine feasible target depth and program it into the receiver.
Positioning the receiver and using remote display for steering guidance.
Common problems and solutions for the Eclipse receiver.
Common problems and solutions for the Eclipse remote display.
General| Brand | DigiTrak |
|---|---|
| Model | eclipse |
| Category | Test Equipment |
| Language | English |
To Next Page
