Why is DigiTrak Remote Display dark?
If the DigiTrak Remote Display goes dark, the screen contrast may need to be adjusted. To adjust the contrast, push in the execute button while repetitively pushing the right or left toggle arrow, or push the left or right toggle arrow in while repetitively pushing the execute button.
Why is my DigiTrak Test Equipment display dark?
If your DigiTrak Test Equipment display goes dark, the screen contrast may need adjustment. To adjust the contrast, hold in the trigger and repetitively push the toggle to the right or left.
Why is DigiTrak Test Equipment depth information inaccurate?
The elevation of the receiver above the tool may have changed while the trigger was being held in. Release the trigger, position the receiver where you want to take a depth reading, and then hold in the trigger while keeping the receiver at a constant elevation.
How to fix DigiTrak Remote Display that will not turn on?
If your DigiTrak Remote Display will not turn on, ensure the battery is properly installed so that the two exposed terminals make contact with the bottom two springs in the remote display’s battery compartment. Also, the battery voltage may be too low, so try replacing the battery.
Why does DigiTrak Remote Display lock up?
If your DigiTrak Remote Display locks up, the battery is probably dead. Replace the battery with a fully charged battery, and press the execute button to power up the unit.
What to do if DigiTrak Test Equipment display goes blank?
If the DigiTrak Test Equipment display goes blank, the screen contrast may have accidentally been adjusted. If so, push the toggle to the right or left several times (at least 8–10) while clicking the trigger. You can also try changing the transmitter’s battery.
What to do if DigiTrak Remote Display goes blank?
If the DigiTrak Remote Display goes blank, the screen contrast may have accidentally been adjusted. If so, push the right or left toggle arrow several times (at least 8–10) while pushing in the execute button, or push in the right or left toggle arrow while repetitively pushing the execute button. You may also try changing the transmitter’s battery.
Detailed steps for 1-point and 2-point calibration of the receiver.
How to adjust key settings like frequency, grade, depth units, and telemetry.
Step-by-step guide for locating the transmitter using the Eclipse system.
How to determine feasible target depth and program it into the receiver.
Positioning the receiver and using remote display for steering guidance.
Common problems and solutions for the Eclipse receiver.
Common problems and solutions for the Eclipse remote display.
General| Brand | DigiTrak |
|---|---|
| Model | eclipse |
| Category | Test Equipment |
| Language | English |
To Next Page
